top of page

Kineranstcentrum groep

Openbaar·1 lid

Official Wiko Bloom 2 Stock Rom


Official Wiko Bloom 2 Stock Rom




The Wiko Bloom 2 is a budget-friendly smartphone that was released in 2015. It features a 4.7-inch IPS LCD display, a MediaTek MT6582M chipset, 1 GB of RAM, 8 GB of internal storage, an 8 MP rear camera, a 2 MP front camera, and a 2120 mAh battery . The device runs on Android 5.0 Lollipop out of the box.


Download File: https://urlcod.com/2w4eYv


If you are looking for the official stock firmware (ROM) for your Wiko Bloom 2, you have come to the right place. In this article, we will provide you with the download link and the installation guide for the official Wiko Bloom 2 stock ROM. By flashing the stock ROM, you can restore your device to its original state, fix any software issues, unbrick your device, or upgrade or downgrade your Android version.


Download Official Wiko Bloom 2 Stock Rom




The official Wiko Bloom 2 stock ROM is available for download from the link below. The file size is about 600 MB and it is in zip format. You will need to extract the zip file to get the firmware file and the flash tool.






How to Install Official Wiko Bloom 2 Stock Rom




Before you proceed with the installation, make sure that you have backed up your important data, as flashing the stock ROM will erase everything on your device. You will also need a Windows PC and a USB cable to connect your device to the PC.


Follow the steps below to install the official Wiko Bloom 2 stock ROM:



  • Download and install the USB drivers for your device from .



  • Extract the zip file that you downloaded in the previous section and open the folder.



  • Run the flash tool (SP Flash Tool) as administrator.



  • Click on the Scatter-loading button and browse to the folder where you extracted the zip file. Select the scatter file (MT6582_Android_scatter.txt) and click Open.



  • Make sure that all the partitions are checked and click on Download.



  • Turn off your device and remove the battery (if possible).



  • Connect your device to the PC using the USB cable. The flash tool will detect your device and start flashing the stock ROM.



  • Wait for the process to complete. You will see a green circle with a check mark when it is done.



  • Disconnect your device from the PC and insert the battery (if removed).



  • Turn on your device and enjoy the official Wiko Bloom 2 stock ROM.




Congratulations! You have successfully installed the official Wiko Bloom 2 stock ROM on your device. If you have any questions or problems, feel free to leave a comment below.


Over

Welkom bij de groep! Je kunt contact leggen met andere leden...
bottom of page